Removing fitting trim: Audi A2
Step-by-step removing fitting trim for the Audi A2: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A2 (8Z)
Don't miss
- Speed nut (4) must be in position on installation.
📋 Procedure
- Remove seat .
- Remove backrest adjuster (2).
- Vehicles with seat height adjuster: Move seat pan (3) upwards.
- Unscrew bolt (4) from underneath.
- Push up fitting trim (1) (direction of arrow).
- Detach fitting trim (1).
- On installation, place fitting trim (1) in position, slide downwards and guide in lower lug (3).
- Slide in at guides (2) (2x).
- Lift upper lug (3) over backrest frame.
- Speed nut (4) must be in position on installation.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing coolant distributor housing – Audi A3
- Removing and installing additional ATF filter – Audi A8 D3
- Removing and installing hose connection with thermostat – Audi
- Removing and installing air cleaner (left-side) – Audi A8 D3
- Removing and installing Lambda probe G39 (before catalytic converter at front right)
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.