Removing and installing Y-pipe (right-side): Audi A6 C6 5.2 (BSM, BXA)

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

• Renewed: gaskets

Don't miss

• Shown in illustration when installed.

🔧 Engine codes this applies to

📋 Procedure

1. Open quick-release fasteners (2) and remove rear noise insulation.
2. Remove electrical connectors (1) and (2) for Lambda probes from bracket.
3. Unplug electrical connector (1).
4. Unbolt cross piece from subframe (arrows).
5. Loosen clamp (right-side) (1) and move to rear.

6. Unscrew bolt (arrow) at bracket for exhaust pipes (right-side).
7. Remove nuts (1) and (2) and detach Y-pipe together with front silencer.
8. Remove nuts (arrows) and detach front silencer (right-side) from Y-pipe. [Note: Shown in illustration when installed.] [Note: Renew gaskets and self-locking nuts.]
9. Install cross piece for subframe 40.
10. Align exhaust system so it is free of stress .

Other AUDI procedures

• Removing and installing engine oil cooler – Audi TT Mk2
• Removing and installing fuel gauge sender 3G237 (tubular sender, left-side)
• Removing and installing coolant temperature sender G62 – Audi
• Removing and installing ignition coils with output stages
• Removing and installing air mass meter G70 (cylinder bank 1)
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures