Removing and installing windscreen washer fluid level sender G33 — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

📋 Procedure

1. Switch off ignition and take out ignition key.
2. Remove front section of front right wheel housing liner 66.
3. Remove fog light .
4. Remove noise insulation 50.
5. Remove closure plate for bumper cover 63.

6. Place drip tray under washer fluid reservoir.
7. Unplug electrical connector (3).
8. Pull windscreen washer fluid level sender G33(item 1) out of washer fluid reservoir (4).
9. Check sealing grommet (2) for damage.
10. Install fog light .
11. Install noise insulation 50.
12. Install closure plate for bumper cover 63.
13. Install front section of front right wheel housing liner 66.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing starter, 2.0 l TFSI engine, vehicles as of model year 2010
• Removing and installing wiper blades, vehicles without joint-free windscreen wipers
• Checking and adjusting angle of incidence of wiper blades, vehicles without joint-free windscreen wipers
• Removing and installing right rear window wiper motor, vehicles with rear wing doors
• Removing and installing gap cover of steering column