Removing and installing windscreen washer fluid level sender — AUDI
Removing and installing windscreen washer fluid level sender on Audi: 13 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes S1, 2H
Don't miss
- For reasons of clarity, the illustration shows the fitting location of the washer fluid reservoir without the wing.
- Insert seal (3) in opening in washer fluid reservoir (4), and make sure it is seated correctly.
📋 Procedure
- Switch off ignition and all electrical loads, and pull out ignition key.
- Remove front right wheel housing liner General body repairs, exterior66Wheel housing liner; Removing and installing wheel housing liner.
- Remove filler pipe for washer fluid reservoir . [Note: For reasons of clarity, the illustration shows the fitting location of the washer fluid reservoir without the wing.]
- Unscrew securing bolts (arrows) from washer fluid reservoir.
- Lower washer fluid reservoir as far as the connected lines allow to gain access to the windscreen washer fluid level sender G33.
- Release and disconnect connector (1) on windscreen washer fluid level sender G33(2).
- Place a drip tray under washer fluid reservoir, and collect any escaping washer fluid.
- Pull windscreen washer fluid level sender G33(2) out of seal (3) in the washer fluid reservoir (4).
- If necessary, remove seal (3) from washer fluid reservoir.
- Insert seal (3) in opening in washer fluid reservoir (4), and make sure it is seated correctly.
- Moisten seal (3) with washer fluid so that windscreen washer fluid level sender G33 can be inserted more easily.
- Push windscreen washer fluid level sender G33(2) completely into seal.
- Connect and engage connector (1).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing gearbox - vehicles with 6-cylinder petrol engine
- Removing gearbox - vehicles with 8-cylinder engine – Audi
- Automatic gearbox 01L, four-wheel drive — Removing and installing gearbox - vehicles with 8-cylinder petrol engine
- Audi 1.8 gearbox removal & installation
- Removing and installing cylinder head cover – Audi TT Mk1
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.