Removing and installing window switches on driver's side - Sportback — AUDI
Removing and installing window switches on driver's side - Sportback on Audi: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A3 (8P, 2003–2012)
📋 Procedure
- Switch off ignition and take out ignition key.
- Remove door trim (front) 70.
- Detach insulating mat from door trim.
- Unscrew bolts (arrows) and detach armrest.
- Unplug electrical connector.
- Release retaining hooks on armrest side by pressing retaining element (arrows).
- Use small screwdriver to carefully release retaining hooks (2) and (3) on side of trim.
- Pull window switch (1) downwards out of switch mounting.
- Press window switch into switch mounting until retaining hooks engage.
- Install door trim (front) 70.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing knock sensor 4 G199 - vehicles up to model year 2013
- Refrigerant circuit with expansion valve
- Renewing front and rear oil seals for intermediate shaft
- Renewing gasket between front intermediate housing and gearbox housing
- Servicing rear wheel brake (disc brake)
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.