Removing and installing wind deflector motor V252: Audi A8 D4

🧭 Before you start

Fits: Audi A8 D4 (4H, 2010–2017)

📋 Procedure

1. Open sliding sunroof fully.
2. Switch off ignition.
3. Remove wind deflector .
4. Remove interior light Electrical system96Controls; Removing and installing interior light/reading light (front).
5. Unplug connector for wind deflector motor (1).

6. Press positioner (2) downwards in direction of (arrow) into sunroof until Torx bolt (1) becomes visible.
7. Unscrew Torx bolt (1) from rear at wind deflector motor.
8. Reach through opening for interior light and unscrew bolt (arrow) from wind deflector motor (1).
9. Connector (1) unplugged
10. Facing forwards, swivel down wind deflector motor by approx. 90°.
11. Pull out motor to rear.
12. Guide motor through opening for light.
13. Insert positioning lever (2) in opening in front part of frame and pin (arrow) in both elongated holes in positioner.
14. Move motor to attachment position.
15. Secure motor with the two bolts.
16. Plug motor in.
17. Fit trim for light opening.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing centre console (rear) – Audi A6 C6
• Removing and installing three-point seat belt (front) with pyrotechnic belt tensioner and switchable belt force limiter (country-specific)
• Removing and installing backrests, front (standard seats)
• Removing and installing internal heat exchanger – Audi
• Removing and installing expansion valve with refrigerant shut-off valve 2 for hybrid battery N517, vehicles with high-voltage system