Removing and installing water tank — AUDI

🧭 Before you start

Fits: platform code SG

Don't miss

• When connecting gas line, ensure that it is secured at angle (1) of 30°, (angle α).
• A leak test must be performed before the liquid gas units are used again!

📋 Procedure

1. ⚠ Observe safety precautions: Liquid gas units . — Remove 2-seater bench seat/bed .
2. Removing roof storage compartment .
3. Disconnect battery on left in engine compartment Electrical system27Battery; Disconnecting and connecting battery.
4. Remove left front seat General body repairs, interior72Front seats; Removing and installing front seat.
5. Disconnect second battery A1 under left front seat Electrical system27Battery; Disconnecting and connecting battery.

6. Remove gas bottle .
7. Remove battery for special vehicle A24.
8. Remove cupboard .
9. Open cupboard doors behind refrigerator box.
10. Remove lid (1).
11. Disconnect connector (2).
12. Unscrew cover (3) with union nut key3218.
13. Disconnect connector of water pump V36.
14. Unscrew three bolts (arrows) on underside of cupboard.
15. Loosen clamp (1) on rear side.
16. Pull fresh water line (2) off water tank (3).
17. Remove bolt (1).
18. Detach clamp (2) from bracket (3).
19. Unscrew union nut (4).
20. Detach gas line (5) from water tank (6).
21. Pull gas line initially towards rear and then upwards until water tank can be removed from cupboard.
22. When connecting gas line, ensure that it is secured at angle (1) of 30°, (angle α).
23. A leak test must be performed before the liquid gas units are used again!

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing control unit for seat ventilation and seat heating
• Removing and installing throttle valve module J338 / J544
• Removing and installing radioR, MMI – Audi A5 Cabriolet
• Removing and installing pop rivet nut for head restraint (rear)
• Removing and installing upper links (coil springs) – Audi