Removing and installing water radiator for charge air cooling circuit - Audi RS 6/RS 7 — AUDI
Removing and installing water radiator for charge air cooling circuit - Audi RS 6/RS 7 on Audi: 10 steps, engines CEUC, CEUD, CRDB, CTGE.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6/A7 C7 (4G, 2011–2018)
- Special tools named: 3094
📐 3 workshop diagrams for CEUC
Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.
📋 Procedure
- Remove bumper cover (front) General body repairs, exterior63Bumper (front); Removing and installing bumper cover.
- Release fasteners (arrows) and detach air duct (1) towards front.
- Move coolant line clear (arrow).
- Remove bolts (2) and nuts (3), detach air duct (1).
- Remove condenser Heating, air conditioning87Refrigerant circuit; Removing and installing condenser.
- Place drip tray for workshop hoistVAS 6208 underneath.
- Clamp off coolant hoses using hose clamps 3094, release hose clips (2, 3) and disconnect coolant hoses.
- Unscrew bolts (arrows), detach water radiator for charge air cooling circuit (1) towards left side of vehicle and remove. [Note: If there are slight impressions on the fins, refer to .Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.The coolant in the entire system must be changed if the radiator is renewed.]
- Install bumper cover (front) General body repairs, exterior63Bumper (front); Removing and installing bumper cover.
- Check coolant level .
Ask TorqFix about your Audi CEUC — it answers with the exact sequence for that engine and the workshop drawing for each step. First question is free after a 20-second sign-up, no card.
Ask about your Audi CEUC — free → or sign up free to see the drawingsOther AUDI procedures
- Separating engine and gearbox, Audi RS 6/RS 7 · 2 torque figures
- Removing and installing secondary air inlet valve N112/N320
- Separating engine and gearbox, Audi S6/S7 · 2 torque figures
- Removing and installing coolant pipe (bottom left) – Audi
- Removing and installing drive chain for auxiliary drive · 3 torque figures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.