Removing and installing charge air cooling pump V188 - vehicles without water radiator (left-side) for charge air cooling circuit — AUDI

🧭 Before you start

Fits: Audi Q5 (8R, 2008–2017)

Don't miss

• Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.

🔧 Engine codes this applies to

📋 Procedure

1. Remove front left wheel.
2. Remove wheel housing liner (1) (front left) General body repairs, exterior66Wheel housing liners; Exploded view - wheel housing liner (front).
3. Unplug electrical connector (4).
4. Use hose clamps 3094 to clamp off coolant hoses at charge air cooling pump V188.
5. Release hose clips (2) and detach coolant hoses.

6. Remove nuts (3) and bolt (5) and detach charge air cooling pump V188 with bracket.
7. If charge air cooling pump V188 is to be removed from bracket, unscrew nut (1). [Note: Secure all hose connections with the correct type of hose clips (same as original equipment) Electronic parts catalogue.]
8. Install front wheel housing liner General body repairs, exterior66Wheel housing liners; Exploded view - wheel housing liner (front).
9. Fit front wheel Running gear, axles, steering44Wheels, tyres; Tightening torque for wheel bolts.
10. Fill up with coolant .

Other AUDI procedures

• Checking fuel pressure and residual pressure, vehicles with 2.0 ltr. TFSI engine from model year 2013 onwards
• Removing and installing drive unit and damper spring – Audi Q7
• Removing and installing regulating flap control unit J808
• Removing and installing vacuum unit for actuating intake manifold flaps, cylinder bank 2 (left-side)
• Checking supercharger for leaks – Audi A6/A7 C7
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures