Removing and installing washer fluid reservoir - Audi Q3 — AUDI

🧭 Before you start

Fits: Audi Q3 (8U, 2011–2018); platform code 84

📋 Procedure

1. Remove filler neck for washer fluid reservoir .
2. Vehicles up to model year 2014: Remove front fog light (left-side) .
3. Vehicles from model year 2015 onwards: Remove headlight housing .
4. Remove wheel spoiler and front left wheel housing liner General body repairs, exterior66Wheel housing liners; Removing and installing wheel housing liner (front).
5. Place drip tray under washer fluid reservoir.

6. Unplug electrical connectors (3, 4, 6) and detach wiring harness (5) from retainers on washer fluid reservoir.
7. Release retaining clips (7, 8)(arrows) and pull washer fluid hose off washer pump.
8. Press release tab (1) and pull washer fluid hose (2) off headlight washer system pump.
9. Remove nuts (1, 3) and bolt (2).
10. Detach washer fluid reservoir (4).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Part II: Balance shaft assembly with oil pump - exploded view · 1 torque figures
• 8-cylinder direct petrol injection engine (4.2 ltr. 4-valve RS 4), mechanics — Securing engine to engine and gearbox support
• Removing and installing dash panel cover (driver side) – Audi
• Removing and installing centre console trim (rear) – Audi
• Removing and installing outer three-point seat belt (rear) - Saloon