Removing and installing filler neck for washer fluid reservoir — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

Don't miss

• Disregard (item 2).
• If necessary, disengage fuel hoses from retainer.Disregard (items 5 and 6).

📋 Procedure

1. Press release tab and detach vacuum line (1) for activated charcoal filter. [Note: Disregard (item 2).]
2. Detach vacuum hose from coolant pipe.
3. Lift off release tab (1)(arrow A) and pull activated charcoal filter (2) (with hose connected) out of bracket (arrow B).
4. Place activated charcoal filter to one side.
5. Detach engine cover panel (arrows).

6. Loosen bolt (1).
7. Remove bolt (2) and nut (3).
8. Detach hose retainer (4) at fuel filter and place fuel filter (7) to one side (with fuel hoses connected). [Note: If necessary, disengage fuel hoses from retainer.Disregard (items 5 and 6).]
9. Remove bolt (1).
10. Pull filler pipe with filler neck (2) off washer fluid reservoir (3).
11. Slide filler pipe (3) onto washer fluid reservoir (1) as far as stop.
12. Install fuel filter 20.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing top part of sump – Audi A8 D2 2.8
• Removing and installing subframe - front-wheel drive – Audi
• 5-speed manual gearbox 085 DS — Exploded view of gear actuator · 5 torque figures
• Removing and installing toothed belt, vehicles 01.06 ►
• Installing gearbox, four-wheel drive