Removing and installing vane pump, 4-cylinder and 6-cylinder petrol engines — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E)

• Opens: power steering fluid

📋 Procedure

1. Clamp off suction hose at reservoir using hose clamp, up to 25 mm3094.
2. Release tension on poly V-belt 27Alternator C; Removing and installing alternator C.
3. Clamp off suction hose on vane pump with hose clamps up to 25 mm diameter3094.
4. Remove suction hose.
5. Unbolt pressure line.

6. Catch escaping hydraulic fluid.
7. Unbolt power steering pump from bracket and remove pump.
8. Install vane pump in bracket and tighten bolts.
9. Attach pressure line with new seals and tighten .
10. Attach suction hose.
11. Remove hose clamps.
12. Lay poly V-belt over pulleys and tension belt 27Alternator C; Removing and installing alternator C.
13. Fill with hydraulic fluid.
14. Bleed steering system and check for leaks .
15. Check power steering fluid level or .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Renewing ball bearing for input shaft
• Removing and installing ATF pump in ATF supply unit
• Removing and installing centre differential housing with gearbox removed
• Four-wheel drive - renewing flange shaft oil seal (right-side) with gearbox removed
• Removing and installing combination valve (right-side) - USA vehicles