Removing and installing valve block for lumbar support air cushions, seat and backrest bolster adjusters - from 09.2012 onwards — AUDI
Removing and installing valve block for lumbar support air cushions, seat and backrest bolster adjusters - from 09.2012 onwards on Audi: 10 steps.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X
Don't miss
- To carry out repairs, the pneumatic line from the compressor is not disconnected at the connection; instead it is severed according to the procedure described .
- Before disconnecting pneumatic lines, mark allocation of lines to connections on valve block with a waterproof felt-tip pen.
📋 Procedure
- Remove backrest cover panel . [Note: To carry out repairs, the pneumatic line from the compressor is not disconnected at the connection; instead it is severed according to the procedure described .]
- Sever pneumatic line (1) to valve block N475/N477 at the following point:
- Unplug electrical connector (8).
- Before disconnecting pneumatic lines, mark allocation of lines to connections on valve block with a waterproof felt-tip pen.
- Disconnect pneumatic lines (1 ...7) at valve block (A).
- To do so, press release mechanism (2)(arrow) and disconnect pneumatic line (1) at the same time.
- Pull rubber buffers to lengthen them (arrow A).
- At the same time, pull valve block off rubber buffers (arrow B).
- Connect pneumatic line .
- Press pneumatic lines on again and then pull lines to check that plug-in connectors are engaged properly.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Installing air hoses and hose clips – Audi 5.0 BUH
- Removing and installing fuel gauge sender 3 G237 (up to model year 2013)
- Adjusting selector mechanism (vehicles from 11.00 onwards)
- Removing and installing washer fluid reservoir – Audi A4 B8
- Removing and installing mechanical exhaust gas recirculation valve
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.