Removing and installing valve block — AUDI

🧭 Before you start

Fits: platform code 42

📋 Procedure

1. ⚠ Risk of injury due to pressurised hydraulic system.The hydraulic pressure in the system must be released before working on the convertible roof system . — With ignition switched off, press and hold convertible roof actuation button E137 for approx. 5 seconds.
2. Observe the rules for cleanliness .
3. Remove back panel trim 70.
4. Open abrasion guard (1) and (4).
5. Unfasten quick-release couplings for hydraulic lines. To do so, release locking springs (arrows) and pull apart hydraulic lines (2) and (3).

6. Unplug electrical connectors (1, 2, 4, 5, 6).
7. Remove bolts (arrows).
8. Detach valve block (3) towards front from rollover bar.
9. If valve block is renewed:
10. If hydraulic line is renewed:
11. Install hydraulic line , .
12. Fill and bleed hydraulic system .
13. Install back panel trim 70.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing right (front passenger side) heat exchanger · 1 torque figures
• Removing and installing catalytic converter with front exhaust pipe
• Removing soft top cover – Audi TT Mk1
• Removing and installing wiper motor with wiper frame – Audi A2
• Removing and installing selector lever cable on vehicles with 3.2 ltr. FSI engine with vehicle ID No. up to 8E_8A 002699