Removing and installing trim panels for base of centre armrest — AUDI

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

Don't miss

• Ensure that the trim engages correctly.

📋 Procedure

1. Remove centre armrest (front) .
2. Remove storage compartment for centre armrest (front) .
3. Fold base of centre armrest (2) upwards as far as it will go (arrow).
4. Lever out gasket (1) using a small screwdriver.
5. Unclip front trim for base of centre armrest (1) using a small screwdriver (arrow) and then remove trim.

6. Fold base of centre armrest (1) downwards as far as it will go (arrow).
7. Open centre armrest (front).
8. Unhook retaining tab (3) of rear trim for base of centre armrest (2) at support for centre armrest (front).
9. Remove rear trim for base of centre armrest.
10. Ensure that the trim engages correctly.
11. Install centre armrest (front) .
12. Install storage compartment for centre armrest (front) .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking multi-function switch F125 with 8-pin connector
• Removing and installing master cylinder – Audi TT Mk1
• Checking ignition coils with output stages – Audi TT Mk1 1.8
• Removing and installing air supply unit (vehicles with 6-cylinder and 8-cylinder petrol engines)
• Removing moulded headliner – Audi A8 D3