Removing and installing trim of seat with height adjustment — AUDI
Removing and installing trim of seat with height adjustment on Audi: 11 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Caddy IV (SA, 2015–2020)
Don't miss
- For greater clarity, drawer is not shown in Figure.
📋 Procedure
- Remove front seat .
- Remove belt buckle
- Lever locking mechanism (1) downwards from side using 2 screwdrivers and pull out drawer from mounting. [Note: For greater clarity, drawer is not shown in Figure.]
- Lever out covers (2) from mountings in adjustment lever using a small screwdriver.
- Undo screws (3) and remove adjustment lever (4).
- Unscrew screws (5) and (6) and remove trim (7).
- Remove bolts (8) (Qty. 10).
- Detach trim from seat frame.
- Using assembly tool3399, acquire a grip on a detent behind backrest adjusting wheel (9).
- Lever assembly tool3399 outwards (arrow A) and detach backrest adjusting wheel from seat.
- Detach trims (10) and (11) from mountings in seat frame.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing headlight main beam bulb M30/M32 - halogen headlights up to model year 2012
- Removing and installing output module for headlight J667/J668 - up to model year 2012
- Removing and installing entry light in exterior mirror – Audi
- Removing water radiator (front) for charge air cooling circuit
- Brake system — Connecting VAS 5051 B, VAS 5052 and selecting functions
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.