Removing and installing three-point seat belt (rear) in rear shelf — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X

Don't miss

• Make sure electrical connectors are fitted correctly (as far as stop) and engage audibly.Make sure that wiring is not trapped.

📋 Procedure

1. Remove rear seat bench .
2. Remove fixed rear seat backrest .
3. Equipment version with multi-contour seat: Remove multi-contour seat .
4. Remove centre belt end fitting (rear) .
5. Remove rear shelf .

6. ⚠ Observe safety regulations for pyrotechnic components .Observe disposal regulations for pyrotechnic components . — Switch on ignition.
7. With ignition switched on, disconnect battery earth wire Electrical system27Battery; Disconnecting and connecting battery.
8. ⚠ Before handling pyrotechnic components (e.g. unplugging the electrical connector) the mechanic must discharge any static electricity. This can be done by briefly touching the door striker plate, or similar. — Unplug electrical connector.
9. To do so, use a small screwdriver (1) to release connector locking element (3) and unplug electrical connector (2).
10. Slacken off bolt (2).
11. Disengage three-point seat belt (1)(arrow) and lift off.
12. If components of the belt system are removed following an accident, renew the securing bolts for the belt system.
13. Insert three-point seat belt with locating element and bolt (2) in mounting (3).
14. Press three-point seat belt (1) forwards as far as stop (arrow) and at the same time tighten bolt. [Note: Make sure electrical connectors are fitted correctly (as far as stop) and engage audibly.Make sure that wiring is not trapped.]
15. ⚠ When working on a vehicle with the ignition switched on or while the drive system is active, the engine can start unexpectedly and exhaust fumes can cause a health hazard in closed rooms. Moving parts can trap or draw in parts of the body and/or clothing (safety hazard). Before switching on the ignition, perform the following steps:Move selector lever to position PActivate parking brake Switch off ignitionOpen bonnetConnect battery charger (e.g. VAS 5095A) to jump-start connections of 12 V electrical system. Switch on ignition — With ignition switched on, connect battery earth wire Electrical system27Battery; Disconnecting and connecting battery.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Installing gearbox, Audi S1 – Audi A1
• Removing and installing bracket for high-pressure pump · 1 torque figures
• Removing and installing side window - Avant – Audi A4 B8
• Removing and installing boot - hydraulic power steering rack
• Removing and installing timing chain covers (top) – Audi CDUC