Removing and installing bracket for high-pressure pump — AUDI

🧭 Before you start

Fits: Audi A1 (8X, 2010–2018)

Don't miss

• The spindle10-222A/11 is not used until a later step.
• Ensure that sliding bush moves easily (unstick if necessary); otherwise clamping force of sliding bush will be insufficient even at correct torque.

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove high-pressure pump .
2. Remove filler neck for washer fluid reservoir Electrical system92Windscreen washer system; Removing and installing washer fluid reservoir.
3. Set up support bracket10-222A on top edges of body flanges (left and right) and longitudinal member (right-side), as shown in illustration.
4. Screw shackle10-222A/12 onto engine lifting eye (right-side) and attach snap element of hook 10-222A/10.
5. Tighten hook slightly to take up weight of engine/gearbox assembly; do not lift. [Note: The spindle10-222A/11 is not used until a later step.]

6. Remove engine support .
7. Screw retainer T10014 into threaded hole for engine support (tighten to 25 Nm) and attach hook of spindle10-222A/11, as shown in illustration. — 25 Nm (18 lb-ft)
8. Unhook snap element of hook 10-222A/10.
9. Remove bolt (3) and move fuel return line (2) clear at ball stud (1).
10. Unscrew bolts (1) and remove bracket (2) for high-pressure pump.
11. Knock back sliding bush (2) in bracket for high-pressure pump slightly (arrow). [Note: Ensure that sliding bush moves easily (unstick if necessary); otherwise clamping force of sliding bush will be insufficient even at correct torque.]
12. Install filler neck for washer fluid reservoir Electrical system92Windscreen washer system; Removing and installing washer fluid reservoir.
13. Install high-pressure pump .
14. Install engine support .

Other AUDI procedures

• Detaching toothed belt from camshaft · 8 torque figures
• Removing and installing emission control module – Audi A3 · 3 torque figures
• Removing and installing emission control module · 2 torque figures
• Separating engine and gearbox - vehicles with manual gearbox · 4 torque figures
• Installing high-pressure lines · 3 torque figures
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures