Removing and installing three-point seat belt (rear) - Avant — AUDI

🧭 Before you start

Fits: Audi A6 C5 (4B)

Don't miss

• Make sure that belt tensioner igniter wire is clear of belt.
• After installing bolt (3) and belt tensioner igniter wire, fit noise insulation cap (2) over them.

📋 Procedure

1. Remove seat bench (rear) .
2. Unscrew bolt (7).
3. Remove luggage compartment side trim .
4. Detach noise insulation cap (2).
5. Unclip belt tensioner igniter wire at lug (4).

6. Unplug electrical connector (8) at belt tensioner.
7. Remove bolt (3) (1x).
8. Take out automatic three-point seat belt (1) with locating element.
9. Engage belt tensioner (1) with locating element.
10. Clip belt tensioner igniter wire into place at lug (4).
11. Make sure that belt tensioner igniter wire is clear of belt.
12. After installing bolt (3) and belt tensioner igniter wire, fit noise insulation cap (2) over them.
13. Perform remaining installation steps in reverse order of removal.
14. On vehicles with belt tensioners, check belt buckle sensors .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing belt adjuster (rear) – Audi A6 C5 · 1 torque figures
• Removing and installing airbag unit (driver side) on vehicles with sports steering wheel · 1 torque figures
• Removing and installing seat memory control unit – Audi A6 C5 · 1 torque figures
• Vehicles with 1.8 l turbo engine up to 05.2000
• Removing and installing headlight – Audi A6 C5