Removing and installing switch unit on left and right next to steering wheel, Crafter 4MOTION with Achleitner four-wheel drive — AUDI

🧭 Before you start

Fits: platform codes 2EA, 2ED, 2EH, 2EX, 2EB, 2EE, 2EK, 2FC, 2FF, 2FL, 2FZ, 2FG, 2FM

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Unscrew securing bolt (arrow) from left trim under dash panel.
3. Unscrew securing bolts (arrows) from trim.
4. Remove left A-pillar trim General body repairs, interior70Trims, insulation; Pillar and side panel trims; Removing and installing A-pillar trim.
5. Unscrew securing bolt (arrow) at top of trim.

6. Pull out trim completely, along with installed light switch in (direction of arrow) as far as the wiring allows.
7. Press spring clips at top and bottom of switch (arrows) and slide switch forwards out of dash panel.
8. Release and disconnect connector from switch.
9. Connect connector on switch and engage it.
10. Push switch into mounting frame until it engages audibly.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Servicing wheel bearing housing
• Removing, installing and servicing pedal cluster for vehicles with 169 kW engine
• Removing and installing strut and drive shaft
• Removing and installing front door trim (4- and 5-cylinder > 06.93)
• Testing Diesel direct injection system voltage supply – Audi