Removing and installing front door trim (4- and 5-cylinder > 06.93) — AUDI

Window crank
Removing => Fig.
1
Mounting orientation => Fig.
2
Secure screw with locking compound AMV 197 000 01
Tightening torque: 2.5 Nm.

Finger plate bottom section
Locking lug must engage recess in top section when installed

Seal
Cross-head bolt
Qty. 4
For attaching finger plate top section to door trim.

Finger plate top section
Removing and installing => Page
70-9

Adjuster knobs for mirror control
Detach adjuster knobs
Push out of finger plate
Adjusting mirror control => Page
66-31
.

Inside door control
Press in direction of travel
Remove from door trim
Detach Bowden cable => Fig.
3

Lock knob
Not necessary to remove in order to remove trim

Ro remove, rotate approx. 1/2 turn (180o) anticlockwise and detach
To fit, slot into place (knob should protrude 16 mm over locating ring) and rotate approx. 1/2 turn (180o) clockwise

Trim
Number and position of retaining hooks => Fig.
7
Remove trim upward

Insulation
Attach to trim using clips

Shim for retaining hook
Plug-on; for ease of fitting stick on lightly

Adjusting clip
Adjusting => Fig.
4

Adapter, front
Plugged in
Detaching adapter from frame => Fig.
5

Adapter, rear
Plugged in
Detaching adapter from frame => Fig.
6

Window crank seal
=> Fig.
7

Trim plate
Not necessary to remove in order to remove trim

Fig.1
Removing window crank

Push in screwdriver -arrow 1-.
Swivel screwdriver -arrow 2-.
Detach cover -arrow 3-.
Unscrew combi screw.

Fig.2
Installation position, front door window crank

Note:

The illustration shows the left side window crank (right side mirror-image)

Installation position with window closed:
40 ± 20o inclined towards the front
A - Direction of travel

Fig.3
Detaching Bowden cable

Lever off clip -2-.
Detach Bowden cable.

1 -
Seal

Fig.4
Front door trim height adjustment

Adjust height parallel to window slot strip on outside -2-.
Base dimension a = 21 mm

Attach trim and check setting.
Correct height as necessary using adjusting screw -1-.

3 -
Door subframe

Fig.5
Adapter, front

1 -
Adapter
2 -
Door trim

Affix to frame with adhesive D 001 300.

Fig.6
Adapter, rear

1 -
Adapter
2 -
Door trim

Affix to frame with adhesive D 001 300.

Fig.7
Window crank seal/number and position of retaining hooks, front door

1 -
Seal
2 -
Door trim

Arrows indicate retaining hooks.

Removing and installing finger plate

Unscrew screw for finger plate bottom section -2-.
Remove finger plate bottom section towards the rear.
Unscrew screws for finger plate top section -1-.

Raise finger plate slightly at rear and push backwards -arrow A-.
Push down finger plate top section at bending point -arrow B- and withdraw from door trim at front end -arrow C-.
If necessary, use a plastic wedge to lever the finger plate out at the front, masking the levering surface of the wedge with adhesive tape.

Withdraw finger plate top section fully from door trim, starting at front end.
It is essential to do the work in this order.
Remove connectors for electric mirror adjustment and electric windows.