Removing and installing door trim: Audi A4 Cabriolet B6/B7
Step-by-step removing and installing door trim for the Audi A4 Cabriolet B6/B7: 19 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A4 Cabriolet B6/B7 (8H)
Don't miss
- Make sure expanding nut (10) is clipped into door shell (9).
- Make sure all clips (8) (8x) are in position on inside of door trim. Renew damaged clips (8).
- Make sure all clips (2) (6x) are in position on outside of door trim (1).
- When installing, make sure hook (3) is facing upwards
📋 Procedure
- Remove triangular trim for treble loudspeaker .
- Remove trim panel (6).
- Remove bolts (5) (there may be 2 or 4 bolts fitted).
- Remove window regulator switch module (3)96.
- Unscrew bolt (4).
- Unscrew bolt (7).
- Unclip door trim (1) starting at bottom.
- Disengage door trim (1) upwards.
- Unplug connector at window regulator control unit
- Disengage Bowden cable for interior door handle
- Make sure expanding nut (10) is clipped into door shell (9).
- Make sure all clips (8) (8x) are in position on inside of door trim. Renew damaged clips (8).
- Make sure all clips (2) (6x) are in position on outside of door trim (1).
- Continue installing door trim (1) in reverse order of removal.
- Pull Bowden cable (2) out of guide (1).
- Disengage hook (3). [Note: When installing, make sure hook (3) is facing upwards]
- Pull off retaining clip (2).
- Unplug connector (3) from control unit (1) in direction of arrow.
- Press retaining tab (2) and pull out clip (1) in direction of arrow.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing radio/telephone aerial (roof aerial)R51 (Saloon) · 1 torque figures
- Removing and installing aerial amplifier (telephone/radio)R45 (Saloon) · 1 torque figures
- Bleeding fuel system (vehicles up to chassis No. 4BZ 2N 109430 and allroad vehicles)
- Removing and installing relay and fuse carrier in luggage compartment electronics box (left) · 1 torque figures
- Checking engine glow plugs Q6 · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.