Removing and installing starter, vehicles with manual gearbox MQ250, MQ500 — AUDI

🧭 Before you start

Fits: platform codes SF, SG

📋 Procedure

1. Disconnect batteries .
2. Remove noise insulation General body repairs, exterior66Noise insulation; Assembly overview - noise insulation.
3. Release connector (1) and disconnect.
4. Press off cap (2).
5. Unscrew securing nut (3) and remove terminal 30/B+.

6. If fitted, unscrew nut (1) from upper bolt of starterB.
7. If fitted, remove earth cable (2).
8. If fitted, unscrew nut (1) from lower bolt of starterB.
9. If fitted, remove earth cable (2).
10. Unscrew nut (4) and remove retainer (1) with wiring harness attached.
11. Unscrew securing bolts (2) and (5) from starterB(3).
12. Remove starterB(3) downwards.
13. Reconnect batteries .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing trim panel for B-pillar (front door)
• Removing and installing heat shield for tunnel (centre), Audi RS Q3
• Removing and installing belt tensioner (front) - NAR version
• Removing and installing side padding with side airbag (rear)
• Removing and installing washer fluid reservoir - Audi Q3