Removing and installing starter, vehicles with double clutch gearbox, DQ250-6F — AUDI

🧭 Before you start

Fits: VW Caddy IV (SA, 2015–2020)

📋 Procedure

1. Disconnect batteryA.
2. If necessary, remove air filter housing 23Air filter; Removing and installing air filter housing or 24Air filter; Removing and installing air filter housing.
3. Remove noise insulation General body repairs, exterior66Noise insulation; Assembly overview - noise insulation.
4. Depending on vehicle equipment, unscrew nut (2) from lower bolt of starterB(1)and remove earth cable (3).
5. Unscrew bolt (4) from starterB(1).

6. Release connector (3) and disconnect.
7. Press off cap (4).
8. Unscrew nut (5) and remove terminal 30/B+.
9. Unscrew bolt (1) from starterB(2).
10. Remove starterB(2) upwards.
11. Reconnect batteryA.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Replacing wheel bearing
• Removing and installing fuel delivery unit - vehicles with 6-cylinder turbo engine
• Front axle drive and transfer box - exploded view of components
• Dismantling and assembling 1st - 3rd gear clutch -K1- with turbine shaft for gearboxes up to 11.92
• Checking accelerator position sender G79 - vehicles with 6-cylinder engine