Removing and installing starter - vehicles with 4.0 ltr. TFSI engine — AUDI
Removing and installing starter - vehicles with 4.0 ltr. TFSI engine on Audi: 12 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X
Don't miss
- Check whether locking part (1) is properly inserted in starter opening before installing starter.
📋 Procedure
- On vehicles with dual clutch gearbox 0B5: Remove catalytic converters 26Emission control system; Removing and installing catalytic converter.
- Remove engine mountings 10Assembly mountings; Removing and installing engine mountings.
- Remove front wheel housing liner General body repairs, exterior66Wheel housing liners; Removing and installing wheel housing liner (front).
- On vehicles with automatic gearbox 0BK: Remove noise insulation (rear) General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
- Unscrew bolts (arrows) and detach heat shield.
- Remove nut (2) and move earth cable clear at engine support (right-side).
- Remove bolts (arrows) and detach engine support (right-side) (1).
- Unplug connector (4) by sliding locking element to rear and pressing down release catch.
- Unscrew nut (3) and detach B+ wire from solenoid switch.
- Remove bolts (1, 2).
- Detach starter (5).
- Check whether locking part (1) is properly inserted in starter opening before installing starter.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Testing accelerator pedal position sender -G79 - vehicles with 6-cylinder engine
- Servicing wheel bearing housing with V.A.G 1459 B
- Exploded view for vehicles with 6-cyl. engines except 5-valve turbo (bi-turbo)
- Removing and installing vane pump (vehicles with 4-cyl. engines)
- Removing and installing vane pump (vehicles with 6-cyl. 5-valve turbo petrol engine - bi-turbo)
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.