Removing and installing starter - vehicles with 2.0 ltr. TFSI engine and high-voltage system — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X

Don't miss

• (Item 1) is accessible from above.
• On vehicles with automatic gearbox, check whether locking part (1) is properly inserted in starter opening before installing starter.
• Risk of damage to starter.To tighten bolt (2), spacer sleeve (arrow) must be inserted between starter and gearbox. — Connect battery. Steps required .

📋 Procedure

1. Disconnect earth cable from batteries with ignition switched off .
2. Remove catalytic converter 26Emission control system; Removing and installing catalytic converter.
3. Remove engine mounting (right-side) 10Assembly mountings; Removing and installing engine mountings.
4. Remove nut (1) and move earth cable clear at engine support.
5. Remove bolts (arrows) and detach engine support (right-side).

6. Unscrew bolts (1, 4) and detach starter. [Note: (Item 1) is accessible from above.]
7. Unplug connector (3) by sliding locking element to rear and pressing down release catch.
8. Unscrew nut (2) and detach B+ wire from solenoid switch.
9. On vehicles with automatic gearbox, check whether locking part (1) is properly inserted in starter opening before installing starter.
10. ⚠ Risk of damage to starter.To tighten bolt (2), spacer sleeve (arrow) must be inserted between starter and gearbox. — Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Automatic gearbox 01L, four-wheel drive — Removing and installing gearbox - vehicles with 8-cylinder petrol engine
• Audi 1.8 gearbox removal & installation
• Removing and installing cylinder head cover – Audi TT Mk1
• Removing and installing exhaust manifold – Audi TT Mk1
• Installing sump (top section) - engines with moulded gasket · 4 torque figures