Removing and installing starter - vehicles with 2.0 ltr. TFSI engine and automatic gearbox — AUDI

🧭 Before you start

Fits: Audi Q3 (8U, 2011–2018); platform code 84

• Special tools named: 3094

📋 Procedure

1. Remove air cleaner housing 24Air cleaner; Removing and installing air cleaner housing.
2. Remove battery tray .
3. Clamp off coolant hoses using hose clamps 3094.
4. Remove nuts (arrows) and bolt (3).
5. Unplug electrical connector (2).

6. Move bracket (1) with ATF cooler to one side.
7. Unplug connector (1) by sliding locking element to rear and pressing down release catch.
8. Press off cap (2).
9. Unscrew wire for terminal 30/B+ (3) from alternator.
10. Remove nut (4).
11. Remove noise insulation General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
12. Remove nut (5) and detach bracket (2) for electrical wiring. Leave electrical wiring connected.
13. Remove bolts (3, 5) and lift out starter (4).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Ribbed belt drive for vane pump, alternator and viscous fan
• Removing and installing crankshaft, flywheel/drive plate and sealing flange
• Installing and removing lower part of intake manifold
• Cylinder head - Overview
• Ribbed belt drive for vane pump, alternator and idler wheel; V-belt drive for coolant pump