Removing and installing starter - vehicles with 2.0 ltr. TFSI/2.0 ltr. TDI engine and manual gearbox — AUDI

🧭 Before you start

Fits: platform code FV

Don't miss

• Depending on version, the earth cable may also be fitted at bolt at top.

📋 Procedure

1. Disconnect earth cable from battery with ignition switched off .
2. Remove air cleaner housing 23Air cleaner; Removing and installing air cleaner housing/24Air cleaner; Removing and installing air cleaner housing.
3. Unplug connector (1) by sliding locking element to rear and pressing down release catch.
4. Press off cap (2).
5. Unscrew wire for terminal 30/B+ (3) from alternator.

6. Remove nut (2).
7. Detach earth cable (1). [Note: Depending on version, the earth cable may also be fitted at bolt at top.]
8. Remove nut (4) and detach bracket (1) for electrical wiring. Leave electrical wiring connected.
9. Unscrew bolts (2, 5) and lift out starter (3).
10. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing mounting bracket (steel wheel bearing housing) · 1 torque figures
• Removing and installing aerial filter (GPS)R110 (Saloon) · 2 torque figures
• Adjusting the front handbrake cable · 2 torque figures
• Removing and installing steering rack, 3rd generation, RHD vehicles, as of model year 2009
• Removing and installing valve stem seals