Removing and installing starter, 2.0 l TFSI engine, vehicles as of model year 2010 with manual gearbox — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

📋 Procedure

1. ⚠ To disconnect and reconnect the battery, the procedure described in the workshop manual should be strictly adhered to . — Disconnect battery .
2. Remove noise insulation (if any) General body repairs, exterior50Body front; Noise insulation.
3. Lever off deflector cap (2) of positive cable fastening from starter solenoid switch.
4. Unscrew securing nut (3) of positive cable (terminal 30) from starter solenoid switch.
5. Release and disconnect connector (terminal 50). (1) on starter solenoid switch.

6. Unscrew securing nut (1) of cable retainer (2) and push cables to one side.
7. Unscrew upper securing bolt (3) for starter.
8. Unscrew securing nut (1) of negative cable (terminal 31) from starter and push cable to one side.
9. Unscrew lower securing bolt (2) for starter.
10. Remove starter.
11. Observe specified torques Assembly overview - starter.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Audi 80/100 V6 14 V, AAH/ABC
• Exploded view: Pipes and hoses (vehicles with V6 TDI engine) · 3 torque figures
• Performing basic setting · 1 torque figures
• Finish balancer · 3 torque figures
• Audi Vehicles with 4-cyl. auxiliary belt replacement · 2 torque figures