Removing and installing starter - 2.0 l diesel engine, manual gearbox — AUDI

🧭 Before you start

Fits: VW Caddy IV (SA, 2015–2020)

📋 Procedure

1. ⚠ To disconnect and reconnect the battery, the procedure described in the workshop manual should be strictly adhered to . — Disconnect battery .
2. Release and disconnect connector (1).
3. Loosen spring-type clip (2) using spring-type clip pliersVAS 5024.
4. Pull vacuum hose (arrow) off air filter housing.
5. Unscrew securing bolt (arrow) of air filter housing.

6. Pull hose (arrow) off air filter housing and remove.
7. Pull air filter housing upwards out of the brackets and remove.
8. Push protective cap off solenoid switch downwards in direction of (arrow).
9. Release and disconnect connector of terminal 50 (2).
10. Unbolt positive cable (1).
11. Unscrew and remove earth wire from bolt securing the starter (arrow).
12. Undo upper starter bolt (arrow).
13. If fitted, remove noise insulation General body repairs, exterior66Noise insulation; Assembly overview - noise insulation.
14. Undo securing nuts (1) and remove cable bracket (2).
15. Undo lower starter bolt (arrow).
16. Remove starter by taking it downwards out of the vehicle.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Exploded view of wheel bearing housing (steel), upper link, lower link, vehicle level sender, coupling rod for anti-roll bar (four-wheel drive vehicles)
• Exploded view of wheel bearing housing (aluminium), wheel bearing unit, coupling rod and link (four-wheel drive vehicles)
• Checking fuel system pressurisation pump G6 (front-wheel drive)
• Removing and installing seat longitudinal adjustment motor V288
• Checking electrical components