Removing and installing starter: Audi R8

🧭 Before you start

Fits: Audi R8 (4S, 2015–)

Don't miss

• B+ wire can only be disconnected after unplugging connector for terminal 50.
• Check whether aluminium bolts can be reused; if so, apply marking.

📋 Procedure

1. Disconnect earth cable from battery with ignition switched off .
2. Remove combination valve for secondary air (left-side) 26Secondary air system; Removing and installing combination valve.
3. Remove spoiler General body repairs, exterior66Spoilers; Removing and installing spoiler.
4. Remove oil reservoir 17Sump/oil pump.
5. Remove cap (6).

6. Unplug electrical connector (1) by sliding locking element to rear and pressing down release catch. [Note: B+ wire can only be disconnected after unplugging connector for terminal 50.]
7. Unscrew nut (2) and detach B+ wires (3, 4) from solenoid switch.
8. Detach gearbox breather (5).
9. Remove bolts (arrows).
10. Press starter (2) upwards off gearbox (1) and detach.
11. Check whether aluminium bolts can be reused; if so, apply marking.
12. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing high-pressure pump - vehicles from 08.2005 onwards
• Removing and installing high-pressure pumps – Audi 5.2 · 1 torque figures
• Re-determining shim "“S"4” when renewing bearing housing · 1 torque figures
• Removing and installing seat occupied sensor (front passenger side)G128
• Removing and installing exterior mirror – Audi Q7 · 1 torque figures