Removing and installing speech input control unit J507: Audi A4 Cabriolet B6/B7

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H)

Don't miss

• Seat belt at seat frame does not have to be unfastened.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove front seat (right-side) General body repairs, interior72Front seats. [Note: Seat belt at seat frame does not have to be unfastened.]
4. Remove A-pillar trim (bottom right): General body repairs, interior70Trim.
5. Fold back the floor covering: General body repairs, interior70Trim.

6. Release cover for electronics box (arrows) and remove cover.
7. Unplug electrical connector (2) at speech input control unit J507(1).
8. Remove speech input control unit J507(1) from electronics box.
9. Installation is performed in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking solenoid valve for boost pressure control – Audi 1.8
• Checking the solenoid valve 1 for the activated carbon canister
• Checking lambda probe heater -Z19 for lambda probe upstream of catalytic converter
• Checking Motronic current supply relay -J271
• Checking Lambda probe heating before catalyst – Audi 1.6 BAH