Removing and installing sliding sunroof frame, sliding panoramic sunroof — AUDI

🧭 Before you start

Fits: Audi A8 D4 (4H, 2010–2017)

Don't miss

• Observe tightening sequence in order to avoid noises while driving.

📋 Procedure

1. Remove glass panels (front and rear).
2. Remove wind deflector.
3. Remove mounting frame for sunroof sun blind.
4. Lower headliner General body repairs, interior70Roof trim panels; Removing and installing moulded headliner.
5. Disconnect electrical wiring at connector.

6. Detach water drain hoses from roof.
7. Remove nuts from sunroof frame.
8. Lift out sunroof frame through roof opening.
9. Installing
10. Install in reverse order, aligning sunroof frame centrally at front and rear using ∅ 12 mm drill bit .
11. When installing sunroof frame, align it centrally next to sunroof motor at front right according to elongated holes (arrow) at front right ...
12. ... and rear centre (arrow) using e.g. ∅ 12 mm drill bit.
13. Tighten nuts -1- and -2- in centre of sunroof frame . [Note: Observe tightening sequence in order to avoid noises while driving.]
14. Tighten bolts to specified torque one after the other in sequence 1 to 18.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Renewing flange shaft oil seal (right-side) at bevel box (outer), four-wheel drive
• Checking fuel gauge senderG, vehicles from model year 2013 onwards
• Renewing inner seal – Audi Q5
• Checking fuel pressure of fuel pump – Audi Q5
• Removing and installing MPI injectors – Audi Q5