Removing and installing selector lever lock solenoid N110 on vehicles with vehicle ID No. from 8E_8A 002700 onwards — AUDI
Removing and installing selector lever lock solenoid N110 on vehicles with vehicle ID No. from 8E_8A 002700 onwards on Audi: 14 steps.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A4 Cabriolet B6/B7 (8H), Audi A4 B6/B7 (8E)
Don't miss
- The shift unit must be renewed if the retaining hook (A) breaks off.
- Ball head (1) must engage fully in operating lever on selector mechanism.
📋 Procedure
- Remove selector lever handle .
- Remove selector mechanism cover (1).
- Unplug electrical connector at selector lever lock solenoid N110.
- Press retaining hook (A) into selector mechanism (arrow) and hold in. [Note: The shift unit must be renewed if the retaining hook (A) breaks off.]
- Tilt bottom part of selector lever lock solenoid N110 out in direction of (arrow) so that ball head (1) disengages from operating lever on selector mechanism.
- Detach selector lever lock solenoid N110.
- Turn ball head (1) into correct installation position.
- Insert selector lever lock solenoid N110 into selector mechanism at an angle from above.
- Tilt bottom part of selector lever lock solenoid N110 in opposite direction of (arrow).
- Ball head (1) must engage fully in operating lever on selector mechanism.
- Secure selector lever lock solenoid N110 with retaining hook (A).
- Install selector mechanism cover (1).
- Install selector lever handle .
- Check function of selector lever lock solenoid N110.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing steering column electronics control unit J527, manufacturer Valeo · 1 torque figures
- Checking variable intake manifold flap change-over valve N239
- Removing and installing right flange shaft
- Removing and installing gas gauge sender G707 · 1 torque figures
- Emptying tank for reducing agent
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.