Removing and installing securing strap recess — AUDI
Removing and installing securing strap recess on Audi: 11 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 2F
📋 Procedure
- Remove nut (2).
- Detach washer (1) and remove.
- Release bonded joint.
- Remove securing strap recess from inside.
- Remove adhesive residue.
- Clean bonding surfaces.
- Clean bonding surfaces.
- Apply sealing and adhesive compound.
- Fit securing strap recess from inside.
- Fit washer (1).
- Tighten nut (2).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing fuel tank chamber (right-side) with attached components
- Dismantling and assembling gearbox - assembly sequence
- Exploded view - oil pan, mechatronic unit, gear oil pump · 5 torque figures
- Removing gearbox - vehicles with 3.2 ltr. MPI engine – Audi
- Removing and installing cylinder head without AVS – Audi
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.