Removing and installing seat trims, Double Cab (without side airbag) — AUDI
Removing and installing seat trims, Double Cab (without side airbag) on Audi: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes S1, 2H
📋 Procedure
- Remove front seat .
- Remove belt buckle .
- Remove storage compartment (8) together with insert (9).
- Turn backrest adjusting wheel (3) until a detent can be seen from the rear. Use a torch if necessary.
- Apply assembly tool3399 behind a detent of backrest adjusting wheel (3).
- Lever assembly tool3399 outwards to detach backrest adjusting wheel (3) from seat (1).
- Remove backrest adjusting wheel (3) with spacer ring (2).
- Unscrew bolts (4), and remove adjustment lever (5).
- Unscrew bolts (6), and remove left trim (7).
- Unscrew bolts (10), and remove right trim (11).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing 8-inch display with kinematic display carrier
- Removing and installing DVD changer – Audi A6/A7 C7
- Removing and installing control unit for night vision system
- Removing and installing rear overhead view camera R246 (Saloon)
- Removing and installing pulley - Denso air conditioner compressor, version 1
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.