Removing and installing rear overhead view camera R246 (Saloon) — AUDI
Removing and installing rear overhead view camera R246 (Saloon) on Audi: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A4 B9 (8W, 2015–)
📋 Procedure
- Switch off ignition and all electrical equipment and remove ignition key.
- Remove rear lid trim (bottom) General body repairs, interior70Luggage compartment trim panels; Removing and installing rear lid trim (bottom).
- Disengage catches (arrows A).
- Remove anti-theft protection (1) from rear lid.
- Release and unplug electrical connectors (2).
- Release catches (arrows B).
- Remove handle (3) from rear lid.
- Install in reverse sequence of removal.
- Close rear lid.
- Perform calibration .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.