Removing and installing seat cushion extension: Audi A6 C5

🧭 Before you start

Fits: Audi A6 C5 (4B)

Don't miss

• Always renew both guide sleeves during installation.

📋 Procedure

1. Move seat upwards as far as it will go.
2. Remove seat .
3. Use pliers or screwdriver to press both springs (2) inwards (arrow).
4. Take out seat cushion extension (1).
5. If fitted, unplug electrical connector for seat heating on both sides.

6. Fold up front cover panel (3) and guide wiring through.
7. If necessary (e.g. to remove seat cushion), remove cover panel completely.
8. Guide connectors of wiring for seat heating on both sides through holes in cover panel (3) and plug in connectors.
9. Attach cover panel.
10. If necessary (e.g. to remove seat cushion), compress guide sleeves (4) with water pump pliers and pull out guide sleeves. [Note: Always renew both guide sleeves during installation.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing steering column electronics control unit J527
• Renewing spur gear – Audi A6/A7 C7
• Filling and bleeding fuel system
• Checking condensation drain – Audi Q3
• Removing and installing cover for fresh air intake – Audi Q3 · 1 torque figures