Removing and installing seat adjustment control element — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

• Renewed: as necessary

Don't miss

• Mark installation dimensions of end stops (3).
• Before installing, check all securing elements for damage and renew as necessary.

📋 Procedure

1. Switch off ignition.
2. Disconnect vehicle battery Electrical system27Disconnecting and reconnecting battery.
3. Remove rotating seat with seat frame on both sides .
4. Remove floor covering (if present) from vehicle.
5. Remove trim on upper left and upper right sides of front bench seat .

6. Remove trim on lower left and lower right sides of front bench seat .
7. Remove lower trim of rear bench seat .
8. Separate front connectors (2) at coupling points (1).
9. Unscrew bolt (2) on seat frame (1) and separate earth connection. [Note: Mark installation dimensions of end stops (3).]
10. Unscrew bolts (2) of end stops (3) in left and right seat rails (1).
11. Unclip end caps (1) for seat assembly opening upwards out of seat rails.
12. Move left and right end stops (1) towards seat assembly opening (2) and remove upwards in (direction of arrow).
13. Push bench seat forwards until seat adjustment control element is accessible.
14. Unscrew bolts (1) and (2)
15. Remove seat adjustment control element from bench seat.
16. Disconnect cable ties from wiring harnesses (arrows).
17. Detach connector (2) from seat adjustment control unit.
18. Detach connector (3) from seat adjustment control element (1). [Note: Before installing, check all securing elements for damage and renew as necessary.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Separating centre and rear silencers · 5 torque figures
• Removing and installing exhaust gas recirculation cooler
• Detaching and re-fitting timing chain on camshafts
• Renewing and adjusting vacuum unit for turbocharger - vehicles with engine code BLS from model year 2008 onwards only · 1 torque figures
• 8-cylinder direct petrol injection engine (4.2 ltr. 4-valve), mechanics — Separating engine and gearbox · 1 torque figures