Removing and installing seal for sliding panoramic sunroof — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X

Don't miss

• The bonding surfaces must be free of dust and grease.Before bonding, heat bonding surfaces and seal to approx. 40° C.
• Peel off protective film from adhesive at rear section of seal and then press on rear section of seal (joint should be in centre of vehicle; observe marking).

📋 Procedure

1. Remove both sunroof panels.
2. Remove frame for sliding panoramic sunroof .
3. Pull seal (1) to the side off body flange. [Note: The bonding surfaces must be free of dust and grease.Before bonding, heat bonding surfaces and seal to approx. 40° C.]
4. Remove any residual adhesive and clean body flange.
5. Clean bonding surfaces on body with cleaning solutionD 009 401 04.

6. Peel off protective film from adhesive at rear section of seal and then press on rear section of seal (joint should be in centre of vehicle; observe marking).
7. Press seal in at front corners.
8. Press on front section of seal.
9. Press seal in at rear corners.
10. Press on rear section of seal.
11. Press on side sections of seal; if necessary, compress seal evenly to take up any excess length.
12. Press seal on all around using roller3356.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing thermostat with housing – Audi A3 4.2
• Renewing camshaft oil seal (toothed belt drive sprocket with M10 securing bolt)
• Removing and installing intermediate pipe (left-side) – Audi
• Bleeding fuel system after installing high-pressure pump
• Removing and installing Lambda probe G39 – Audi A1