Removing and installing satellite tuner aerial R172: Audi A4 Cabriolet B6/B7

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove boot lid trim: General body repairs, interior70Luggage compartment trim panels.
4. Unscrew bolts (arrows) (2 Nm). — 2 Nm (1.5 lb-ft)
5. Unplug connector (3).
6. Unscrew bolts (4) (4 Nm) and detach satellite tuner aerial R172(2) from reverse side of retainer (1). — 4 Nm (3.0 lb-ft)
7. Installation is performed in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing mounting plate for oil cooler, pressure control valve and oil filter housing
• Cleaning (flushing) refrigerant circuit with refrigerant R134a
• Calibrating lane change assist
• Removing and installing swivel joint – Audi Q3 · 2 torque figures
• Servicing constant velocity joint, drive shaft with triple roller joint AAR3300i (with external splines for insertion in gearbox)