Removing and installing roof trim — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T6 (7E)

📋 Procedure

1. Remove bellows .
2. Remove pop-up roof
3. Place pop-up roof onto padded trestles.
4. Remove handle (1) and hook (5) from front roof trim.
5. Using hot air blowerVAS 1978/14A or hot air blowerV.A.G 1416, heat front area of pop-up roof (1) from below.

6. Carefully detach front roof trim (2) completely from pop-up roof (1), and remove it.
7. Using hot air blowerVAS 1978/14A or hot air blowerV.A.G 1416, heat lower area of pop-up roof (1).
8. Carefully pull roof trim (2) in (direction of arrow) off pop-up roof (1).
9. Cut back adhesive residue (2) using scraperVAS 5301/21.
10. Using hand-cartridge gunV.A.G 1628, apply adhesive in centre of residual adhesive sealant (2) which has been cut through before.
11. Fit roof trim onto pop-up roof (1), and press it on carefully.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking turbocharger and charge pressure control - vehicles with plug in intake manifold
• Checking engine speed sender G28 – Audi A8 D2
• Checking delivery of plunger pump - Audi S4/S6 and Audi S6 Plus with 8-cyl. engine
• Removing and installing drive chain sprocket – Audi A1
• Removing and installing cover for selector mechanism and securing frame with gear lever boot