Removing and installing cover for selector mechanism and securing frame with gear lever boot — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

📋 Procedure

1. Unclip securing frame (5).
2. Break open securing clip (6).
3. Pull off gear lever boot with gear knob and securing frame.
4. Attach gear knob (4) to gear lever.
5. Press down gear knob (4) firmly.

6. Use hose clip pliersV.A.G 1275 to fit clip (6).
7. Clip securing frame (5) into cover for selector mechanism.
8. Open ashtray in centre console.
9. Lift off cover (1) with gear lever boot (2).
10. Open ashtray in centre console.
11. Lift off cover for selector lever (arrows).
12. Unclip selector lever boot (1) on both sides and lift it off (arrows).
13. Reach into the opening and lift off the cover (1)(arrows).
14. Unplug electrical connector.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing gas-filled strut – Audi TT Mk1 · 1 torque figures
• Removing and installing gearbox mounting - vehicles with 6-cylinder engine
• Renewing flange shaft oil seal (left-side) - vehicles with 4-cylinder engine
• Renewing flange shaft oil seal (left-side) - vehicles with 6-cylinder engine
• Removing and installing telephone/telematics control unit J526 (telematics system operation) · 1 torque figures