Removing and installing roof rail: Audi Q7

🧭 Before you start

Fits: Audi Q7 (4M, 2015–)

• Renewed: if necessary

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. ⚠ Observe safety regulations for working on pyrotechnic components General body repairs, interior00Safety precautions; Safety precautions when working on pyrotechnic components. — Remove curtain airbag igniter from vehicle body (but leave curtain airbag installed) General body repairs, interior69Curtain airbags; Removing and installing curtain airbag with airbag igniter.
2. Unplug electrical connector (1).
3. Remove nuts (arrows) and move bracket (2) to one side.
4. Remove nuts (1 … 5).
5. Lift off roof rail. [Note: Clean thread of stud on roof rail with a wire brush.Check seal for damage and renew if necessary.Carefully remove any locking fluid residue from the threads of the nuts fitted with locking fluid using a thread tap. Otherwise, the studs could shear off when they are removed again.]
6. Fit roof rail, inserting guide pin in mounting in roof of vehicle.
7. Fit nuts with locking fluid and tighten.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Testing power steering pressure switch -F88 – Audi 1.8
• Servicing intake manifold flap motor -V157 (engine with code letters AXR)
• Adjusting engine mounting
• Removing and installing lower section of intake manifold
• Removing cylinder head - vehicles with engine codes AEH, AKL