Removing and installing rollover bar cross member: Audi TT Mk1

🧭 Before you start

Fits: Audi TT Mk1 (8N)

Don't miss

• Tighten bolts in following sequence.Bolt (3) with spigotArrow points in direction of travel.
• Before fitting rollover bar, make sure rubber guide is correctly positioned

📋 Procedure

1. Remove both rollover bars .
2. Remove loudspeaker assembly mount .
3. Remove wind deflector or trim panel in place of wind deflector .
4. Raise convertible top slightly
5. Remove protective caps for bolts (4)

6. Unscrew bolts (4) (2x).
7. Unscrew bolts (3) (2x).
8. Unscrew bolts (2) (8x).
9. Take rollover bar cross member (1) out of vehicle. [Note: Tighten bolts in following sequence.Bolt (3) with spigotArrow points in direction of travel.]
10. Screw in bolts (3).
11. Screw in bolts (4).
12. Screw in bolts (2) diagonally.
13. Before fitting rollover bar, make sure rubber guide is correctly positioned
14. Perform remaining installation operations in reverse order of removal.
15. Raise convertible top (A) slightly and place screwdriver (B) or plastic wedge between convertible top and convertible top compartment.
16. Use screwdriver to prise off cap (A).
17. Unscrew bolt (4).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Connecting vehicle diagnostic, testing and information systemVAS 5051 and selecting functions
• Brake system — Connecting VAS 505x and selecting functions
• Removing and installing front upper link – Audi A8 D3
• Removing and installing storage compartment/knee bolster (driver's side)
• Removing and installing small storage compartment – Audi A8 D3 · 1 torque figures