Removing and installing cross member: Audi A6 C6
Step-by-step removing and installing cross member for the Audi A6 C6: 7 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6 C6 (4F, 2004–2011)
Don't miss
- Fit new nuts (1), but do not tighten yet.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 60 Nm (44 lb-ft) | Attach suspension struts to cross member |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Position vehicle on lifting platform .
- Remove noise insulation 50.
- If fitted, unscrew nuts (1) and bolts (3) for cross member (2) and detach cross member (2).
- Fit new nuts (1), but do not tighten yet.
- If fitted, tighten bolts (3).
- Tighten nuts (1).
- Vehicles with air suspension: set down vehicle on its wheels .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing dash panel vent control motor V562
- Checking fuel system pressurisation pump G6 - A5 from model year 2012 onwards, A4 with 4-cyl. and 6-cyl. engines from model year 2013 onwards, RS 5 from model year 2012 onwards, RS 4
- Removing and installing fuel pump control unit J538 - rest-of-world vehicles with front-wheel drive
- Installing front interior light W1 with warning lamp for airbag deactivated on front passenger side
- Checking activation – Audi A4 B5
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.