Removing and installing right dash panel trim, Transporter — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

Don't miss

• If trim (1) is not pressed down somewhat prior to being released in the fuse holder area, the fasteners in this area could be damaged.

📋 Procedure

1. Switch off ignition.
2. Open fuse holder.
3. Remove right-hand dash panel side cover .
4. Remove right footwell cover .
5. Remove right dash panel trim .

6. Remove the 7 bolts (3).
7. Pull out right dash panel trim (1) in upper area from mountings.
8. Press down trim (1) and release it from the dash panel in the transition area to the fuse box. [Note: If trim (1) is not pressed down somewhat prior to being released in the fuse holder area, the fasteners in this area could be damaged.]
9. Unhook trim (1) from mounting (2).
10. Pull out trim (1) from centre footwell trim (4)(arrow) and remove trim.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing Bowden cable for backrest release mechanism
• Removing and installing Bowden cable A for Easy Entry system
• Separating engine and gearbox - vehicles with dual clutch gearbox 0D9
• Removing and installing thermostat for large coolant circuit - engine codes CUKB, CXUA
• Servicing drive shaft with 108 mm dia. inner constant velocity joint