Removing and installing reversing camera R189, Saloon: Audi A4 B8

🧭 Before you start

Fits: Audi A4 B8 (8K, 2007–2015)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off ignition and all electrical equipment and remove ignition key.
2. Remove rear lid trim General body repairs, interior70Luggage compartment trim panels; Exploded view - rear lid trim (bottom).
3. Release and unplug connectors (1) and (2) in rear lid.
4. Unscrew nuts (2) from anti-theft device (1) in rear lid.
5. Unscrew nuts (2).

6. Detach anti-theft device (1).
7. Release both retaining tabs (left and right) on handle (3) and pull handle (3) with reversing camera R189 out of rear lid.
8. Install in reverse sequence of removal.
9. Close rear lid.
10. Perform calibration .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing combustion chamber with combustion tube · 1 torque figures
• Removing and installing auxiliary air heater Airtronic D3
• Removing and installing alternator, 3.2 l V6 engine
• Removing and installing alternator, 1.9 l TDI engine
• Removing and installing tachograph sender, 5-speed manual gearbox · 1 torque figures