Removing and installing relay carrier in front footwell (right-side) — AUDI

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

Don't miss

• Exact assignment of contacts in relay carrier in front right footwell can be seen from appropriate current flow diagram .

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. Remove glove box 68.
3. Remove lower A-pillar trim 70.
4. Fold back floor covering.
5. Take out foot rest.

6. Disconnect relay (1).
7. Unscrew bolts (arrows) and detach relay carrier from bulkhead.
8. Disconnect relays/fuses from relay carrier.
9. Unclip fuse holders and relay carriers at relay carrier. [Note: Exact assignment of contacts in relay carrier in front right footwell can be seen from appropriate current flow diagram .]
10. Install lower A-pillar trim 70.
11. Install glove box 68.
12. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing retainers for right control motors (with a "“Low”" or "“Mid”" air conditioner)
• Checking operation of air quality sensor G238 – Audi A8 D4
• Servicing air pipe – Audi A8 D4
• Removing and installing pulley (without N25), "“Denso”" air conditioner compressor version "“1”" · 1 torque figures
• Removing and installing holders for control motors on right "“High”" air conditioner