Removing and installing receiving aerials: Audi A6 C5
Step-by-step removing and installing receiving aerials for the Audi A6 C5: 9 steps, 1 torque figure. What to remove, what to tighten and to how many Nm.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6 C5 (4B)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Tightening torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Removing and installing wheel housing liners General body repairs, exterior66
- Switch off ignition.
- Unplug the connector to the aerial.
- Unfasten the aerial screw connection at the holder.
- Tightening torque: 2 Nm — 2 Nm (1.5 lb-ft)
- Take out the aerial.
- Unfasten the holder screw connection at the body.
- Unfasten the aerial screw connection at the holder.
- Tightening torque: 2 Nm — 2 Nm (1.5 lb-ft)
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing mounting for convertible roof compartment lid hinge
- Removing and installing handbrake cable (rear) – Audi TT Mk2
- Removing and installing floor covering, Coupé – Audi TT Mk2
- Removing and installing alternator - Audi TT and TTS with 2.0 ltr. TFSI engine
- Installing bevel box - vehicles with 2.0 ltr. TFSI engine · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.